Loqni Transmitter
An Attachment for your phone or laptop to communicate outdoors! You could use this for camping. Powered by an Xiao Esp32c3 and Ra-02_module!
Created by
Axe
Tier 4
11 views
0 followers
CAN ⚡🚀
approved Loqni Transmitter ago
Tier approved: 4
Grant approved: $53.00
Awesome project!
Axe
submitted Loqni Transmitter for ship review ago
Axe
added to the journal ago
Finished the Case and Firmware
I have made the base of my case! this is the normal case with cutouts and designs!
-Outside
-Inside (No stl for ra-02 module online!)
-Without bottom cover
All of this consists of 4 parts
-Top cover
-bottom cover
-Bottom Case
-2 custom buttons
Axe
added to the journal ago
Realized that the spacing for my custom footprint was wrong
So thanks to @toby cm he found out my footprint row spacing was wrong for my ra-02 module and also saw that i needed bigger traces for power. So i had to remake my footprint which ran into lots of problems.. like the pins numbering are in a "U" instead of "S" Shape
OLD VERSION:
NEW VERSION: V2
I had to redesign everything
Axe
added to the journal ago
Routed the Pcb and finished it
i have routed it too me like 40mins to do it (if you were wondering why did i jornal another one its because i forgot to jornal the schematic and proceeded to make this)
Axe
added to the journal ago
Started and finished the Schematic
started and finished schematic!
I had to research what was the wiring diagram of the LoRa module but it seems all is good?
also had to make my own symbol and footprint (which was so hard!!)
Axe
started Loqni Transmitter ago
2/23/2026 10:40 PM - Started and finished the Schematic
started and finished schematic!
I had to research what was the wiring diagram of the LoRa module but it seems all is good?
also had to make my own symbol and footprint (which was so hard!!)
2/23/2026 10:50 PM - Routed the Pcb and finished it
i have routed it too me like 40mins to do it (if you were wondering why did i jornal another one its because i forgot to jornal the schematic and proceeded to make this)
2/24/2026 - Realized that the spacing for my custom footprint was wrong
So thanks to @toby cm he found out my footprint row spacing was wrong for my ra-02 module and also saw that i needed bigger traces for power. So i had to remake my footprint which ran into lots of problems.. like the pins numbering are in a "U" instead of "S" Shape
OLD VERSION:
NEW VERSION: V2
I had to redesign everything
2/27/2026 - Finished the Case and Firmware
I have made the base of my case! this is the normal case with cutouts and designs!
-Outside
-Inside (No stl for ra-02 module online!)
-Without bottom cover
All of this consists of 4 parts
-Top cover
-bottom cover
-Bottom Case
-2 custom buttons