Hey! Please add screws to your case, If you would like to continue without screws, the case needs to have a mechanism to secure the two case halves together. Though its not required, you could add a clearer BOM to your repo. The PCB routing looks great. Submission guidelines can be found at https://blueprint.hackclub.com/hackpad/submitting.

Hey! Please listen to previous reviewer you need make it so its screwable together, like the tutorial , so that the top is attached to the bottom case. Also you are using the wrong LEDs please update that ( you can find the right one here . Also can you make an assembled model of the hackpad with the case and the PCB! Do ask in #blueprint or ping me if you need any help with it

Hey! Please use .step, and export PCB from kicad! U dotn neeed 3d models to do that. Also, plese make it so its screwable together, like the tutorial. Nice matrix!

Heyo, you're still missing a few of the aforementioned changes, most notably including your diode footprint - make sure it's through-hole, thanks! :D

This looks great! Just a few things you need to change.

• The footprint you have for the diodes is a much smaller SMD diode. The one included in the kit is through hole and will work with the D_DO-35_SOD27_P7.62mm_Horizontal footprint.
• The plate needs to extend a bit farther out to the edge of the case so you can screw it down.

Also you need a few things in your repo.

• The individual pieces of the case as step files.
• The assembly of the case as a step file. This should include a 3d model of the PCB which you can export from KiCad by going to File -> Export -> STEP....
• If you could organize the repo into a few folders (CAD, PCB, Firmware) that would be great!

Nice work so far on your hackpad! Just upload your cad files as a .stl file and you'll be all good :)