Fume Extractor

An advanced but affordable fume extractor that would've cost a lot more if bought instead of built. Uses HEPA and Granular Activated Carbon that actually filters compared to carbon sponge.

Modular Fin/Canard Stabilisation Module

A modular section built for my model rockets as a canard stabilisation module. This is quite modular and can be used for any 68mm rockets. however I have intended the nature of its design should allow very simple customisation to fit almost any size larger than it.

Rocket motor thrust test stand

I've wanted to build this to benchmark homemade rocket motors, but I never had the time to design one. I even bought a load cell for this, but just didn't get to make it.

LoRa Ground Station Reciever

A receiver to connect to my flight computer.

Waterproof Cyberdeck for outdoor use

I am planning on making this cyberdeck a multipurpose outdoor device to receive any information from my flight computer, and also for other wireless projects. This will be able to connect to my ground station or rocket motor thrust test stand.

Aries - Flight Computer for Model Rockets

I wanted to do a proper flight computer with all the features I could dream of on a PCB. I started my journey of making a flight computer on a perfboard, and it was an extremely time-consuming process. This project should end up with a pretty function-packed flight computer.

CAD Macropad (Hackpad)

A macropad for fusion 360 and kicad. Can also use it to display some status using rgb and oled.