Blueprint

LLs macropad

I will use this as additional keys for my computer when i am designing on onshape

Created by Couchpotatoe1234 Couchpotatoe1234

Hackpad

2 views

0 followers

CAN CAN ⚡🚀 approved LLs macropad ago

Tickets awarded: 80 tickets

Tier: 4

Really cool!

Couchpotatoe1234 Couchpotatoe1234 submitted LLs macropad for ship review ago

cubit010 cubit010 ⚡ requested changes for LLs macropad ago

fixing paglu perma reject!
you should be good to resubmit now!

Tier: 4

Couchpotatoe1234 Couchpotatoe1234 submitted LLs macropad for ship review ago

Couchpotatoe1234 Couchpotatoe1234 added to the journal ago

Finishing touches

I just finished printing the final finishing touches including a case where the PCB won't wobble around in. The design is finished and I have updated my git repo.IMG_0219

Couchpotatoe1234 Couchpotatoe1234 added to the journal ago

Finished Firmware

Today, I decided to have a 2 hour lock-in session to make my firmware. After only one hour though, my firmware was finished! But then, I realized that I had soldered my microcontroller on wrong, so I had to resolder that... But now, all the firmware is done and it works for Onshape keybinds! I will be remaking my case because now it doesn't fit as well. I will also be updating my repo soon. (in the end, turns out I did spend 2 hours...) 146A5113-93E2-485E-B4AD-D166A2E8FFE6_4_5005_c

Couchpotatoe1234 Couchpotatoe1234 added to the journal ago

Soldered the PCB

I all in one session, soldered my entire PCB together, it took a while, but I'm finally done! Now its time to see if my firmware works... I also encountered some problems with my case, including, being to small, and being to short. I will improve on the design sometime later.Screenshot 2026-03-19 at 7.24.38 PM

CAN CAN ⚡🚀 approved LLs macropad ago

Nice hackpad

Couchpotatoe1234 Couchpotatoe1234 submitted LLs macropad for ship review ago

Couchpotatoe1234 Couchpotatoe1234 started LLs macropad ago

3/19/2026 - Soldered the PCB

I all in one session, soldered my entire PCB together, it took a while, but I'm finally done! Now its time to see if my firmware works... I also encountered some problems with my case, including, being to small, and being to short. I will improve on the design sometime later.Screenshot 2026-03-19 at 7.24.38 PM

3/21/2026 - Finished Firmware

Today, I decided to have a 2 hour lock-in session to make my firmware. After only one hour though, my firmware was finished! But then, I realized that I had soldered my microcontroller on wrong, so I had to resolder that... But now, all the firmware is done and it works for Onshape keybinds! I will be remaking my case because now it doesn't fit as well. I will also be updating my repo soon. (in the end, turns out I did spend 2 hours...) 146A5113-93E2-485E-B4AD-D166A2E8FFE6_4_5005_c

3/28/2026 - Finishing touches

I just finished printing the final finishing touches including a case where the PCB won't wobble around in. The design is finished and I have updated my git repo.IMG_0219