LLs macropad
I will use this as additional keys for my computer when i am designing on onshape
Created by
Couchpotatoe1234
Hackpad
2 views
0 followers
CAN ⚡🚀
approved LLs macropad ago
Tickets awarded: 80 tickets
Tier: 4
Really cool!
Couchpotatoe1234
submitted LLs macropad for ship review ago
cubit010 ⚡
requested changes for LLs macropad ago
fixing paglu perma reject!
you should be good to resubmit now!
Tier: 4
Couchpotatoe1234
submitted LLs macropad for ship review ago
Couchpotatoe1234
added to the journal ago
Finishing touches
I just finished printing the final finishing touches including a case where the PCB won't wobble around in. The design is finished and I have updated my git repo.
Couchpotatoe1234
added to the journal ago
Finished Firmware
Today, I decided to have a 2 hour lock-in session to make my firmware. After only one hour though, my firmware was finished! But then, I realized that I had soldered my microcontroller on wrong, so I had to resolder that... But now, all the firmware is done and it works for Onshape keybinds! I will be remaking my case because now it doesn't fit as well. I will also be updating my repo soon. (in the end, turns out I did spend 2 hours...) 
Couchpotatoe1234
added to the journal ago
Soldered the PCB
I all in one session, soldered my entire PCB together, it took a while, but I'm finally done! Now its time to see if my firmware works... I also encountered some problems with my case, including, being to small, and being to short. I will improve on the design sometime later.
CAN ⚡🚀
approved LLs macropad ago
Nice hackpad
Couchpotatoe1234
submitted LLs macropad for ship review ago
Couchpotatoe1234
started LLs macropad ago
3/19/2026 - Soldered the PCB
I all in one session, soldered my entire PCB together, it took a while, but I'm finally done! Now its time to see if my firmware works... I also encountered some problems with my case, including, being to small, and being to short. I will improve on the design sometime later.
3/21/2026 - Finished Firmware
Today, I decided to have a 2 hour lock-in session to make my firmware. After only one hour though, my firmware was finished! But then, I realized that I had soldered my microcontroller on wrong, so I had to resolder that... But now, all the firmware is done and it works for Onshape keybinds! I will be remaking my case because now it doesn't fit as well. I will also be updating my repo soon. (in the end, turns out I did spend 2 hours...) 
3/28/2026 - Finishing touches
I just finished printing the final finishing touches including a case where the PCB won't wobble around in. The design is finished and I have updated my git repo.