Glass Holder
A 3d print to hold glasses scattered at my home
Created by
noctyrnrblx
Tier 5
3 views
0 followers
Iamalive 🚀
approved Glass Holder ago
Tier approved: 5
Grant approved: $18.00
Looks good!
noctyrnrblx
submitted Glass Holder for review ago
Iamalive 🚀
requested changes for Glass Holder ago
If you're only using printing legion to get your project, please update your requested funding and fully explain how you're getting your project. I'm assuming you're just using printing legion?
noctyrnrblx
submitted Glass Holder for review ago
Iamalive 🚀
requested changes for Glass Holder ago
Please include a seperate BOM.csv file. Additionally, your jlcpcb cart doesn't match your requested funding!
noctyrnrblx
submitted Glass Holder for review ago
noctyrnrblx
added to the journal ago
CUT in half | too big
Its 27 cm wide so i cut it from the middle into two parts eaily printable on a printer. because there was very less amoutn of chance that this would be printed in one part so i split it into two then ill used something to stick them
noctyrnrblx
added to the journal ago
Made the holder fully.
I added rectangles and chamfers so that the water can drop down and a gap in the front for cleaning or doing something else too. This holder holds 3 glasses at a time more if stacked glasses
noctyrnrblx
added to the journal ago
Made The Holders Dimensions, Temp Rectangle.
I Made a sketch will all dimensions and added a 95 degree curve outward on the bottom line of the holder so the water can pour down slowly after it is washed
BOTTOM
TOP
noctyrnrblx
added to the journal ago
Made The Holders Dimensions, Temp Rectangle.
I Made a sketch will all dimensions and added a 95 degree curve outward on the bottom line of the holder so the water can pour down slowly after it is washed
BOTTOM
TOP
noctyrnrblx
started Glass Holder ago
1/4/2026 2:56 PM - Made The Holders Dimensions, Temp Rectangle.
I Made a sketch will all dimensions and added a 95 degree curve outward on the bottom line of the holder so the water can pour down slowly after it is washed
BOTTOM
TOP
1/4/2026 2:56 PM - Made The Holders Dimensions, Temp Rectangle.
I Made a sketch will all dimensions and added a 95 degree curve outward on the bottom line of the holder so the water can pour down slowly after it is washed
BOTTOM
TOP
1/4/2026 3:26 PM - Made the holder fully.
I added rectangles and chamfers so that the water can drop down and a gap in the front for cleaning or doing something else too. This holder holds 3 glasses at a time more if stacked glasses
1/4/2026 3:31 PM - CUT in half | too big
Its 27 cm wide so i cut it from the middle into two parts eaily printable on a printer. because there was very less amoutn of chance that this would be printed in one part so i split it into two then ill used something to stick them