1/12/2026 2:06 PM - researched the components and created the schematics

In this step, I started the processes and created a circuit diagram for my project.
I thought of adding various features, like touch response and a sound alert system

1/12/2026 2:08 PM - designing the pcb in circuit mode

In this step, I created the final layout of the device and assembled the components where they should be keeping the device as small as possible while not removing features

1/13/2026 8:39 PM - Routed The PCB

In this step, I finally completed the routing of the PCB, and I also went ahead and created different net classes for ground, 3V3, and 5V so that the device does not overheat when a lot of current is pulled

1/13/2026 8:59 PM - 3d model

So, in this section, I added some missing 3d models to Kicad to complete the 3d file in Kicad 3d viewer. I found most of these files on a website called GrabCAD

1/13/2026 9 PM - made a mistake

I forgot to add the battery pins to the PCB that connects to Seeed Xiaos' in-built battery charger. I cannot solder directly to the seeed cause the pins are inside the module, and it will be SMD soldered to the board