12/2/2025 6:25 PM - Finished the Schematics

All of the schematic portions are done it's TIME TO MOVE ON TO THE PCB :), this took me about 2-3 hours but I forgot to make my project thing in blueprint and started making it... oops.

12/2/2025 6:53 PM - Added Foot Prints

I fully forgot to assign the footprints and I had to go back and add the libraries as well as assign each component its footprint I used the mx cherry switch as it is one I am familiar with.

12/2/2025 8 PM - Routed PCB

I finished the PCB hopefully this works I am not sure how to check if it will work but I have positive it will work around 90% positive I might run it by others to make sure.

12/2/2025 9:19 PM - Made Case

I finished making the cad for the case it took e some time and some help from my robotics teammates
as well as some research but I finally managed to figure it out I think I am almost done just need the BOM

12/2/2025 9:32 PM - BOM

These are all the bills/things I need to buy for this project this is basically the BOM I will attach a seperate BOM file as well to see all the products. Many of the products I couldn't get the shipping cost for since it made me log in but I would assume 100 would cover all of it after shipping.

12/4/2025 6 PM - Completed Assembly

I finished the complete cad of the assembly with the switches, keycap, PCB and it took me some time, tutorials and help from my 3d printing experts I am close with but its finally done.

12/4/2025 8:13 PM - All Cart on Amazon

Here is the cart for all the parts on amazon excluding the JLPCB order. The total after the JLPCB comes out to around 130-140 dollars and then I will also need a solder.

12/4/2025 8:18 PM - AMAZON PRODUCTS

Here are the amazon cart orders FYI if I needed to add that too just to make sure I get this verified to get a chance to go to PROTOTYPE with the rest of my friends.

12/4/2025 8:31 PM - FINISHED REPO

I finished the repo the pic of my final assembly is without the mates so it is easier to see everything but the mates are there just turned off to look more appeasing that is my final assembly though I really hope this gets the thumbs up as I want to go to Prototype. Crossing my fingers :).

12/5/2025 7 AM - Parts to Aliexpress

I have added all the parts and changed everything to aliexpress instead of amazon as instructed by my previous reviewer thanks for the feedback here are the images.

12/5/2025 8 AM - Finished Readme

I added the case as well with all the files including a render of the final thing and the case separately this should be all the images needed I think I am done now.

12/5/2025 9 AM - Changed from STL to STEP

Added the step file hopefully this fixes everything and I am done and this gets approved thanks to the reviewers who have been tortured by my many mistakes :).