Macro Pad
A fully customizable macro pad project using STM32-based controllers.
Created by
Samir Ghimire
Tier 3
8 views
0 followers
Timeline
technical_.
requested changes for Macro Pad ago
Your PCB design journal cannot just be one journal with 74 hours. Please add more journals on the entire PCB design process, from the research, schematic, component placing, etc.
Samir Ghimire
submitted Macro Pad for review ago
Nachu Thenappan 🚀
requested changes for Macro Pad ago
Hi, please decrease your prices for your parts as much as possible this is still way too expensive for a normal macropad, for this to be approved it must be a lot cheaper.
Samir Ghimire
submitted Macro Pad for review ago
Samir Ghimire
added to the journal ago
Finished the 3d model of the case
I just finished the outer case of the 3d model that will hold the pcb and all the components that will contain all the components after everything has been assembled. I have used the 3d model of another macropad's case I
found online and remodelled it to fit my pcb sizes and all
Tanishq Goyal 🚀
requested changes for Macro Pad ago
Please fix your AI, if this continues it may result in a perma ban :/ Also, can you please decrease your cost in ur bom ? its 127.58 right now for a macropad. Typically, they can be made for below 30.
Kai Pereira 🚀
requested changes for Macro Pad ago
Please update the price of your requested grant to be more accurate, and add prices into your BOM! Also replace all your use of AI in your readme please!
Samir Ghimire
submitted Macro Pad for review ago
Samir Ghimire
added to the journal ago
Details on the things
What i have done is made a 16 key hot swappable keyswitches, macro keyboard that can be used as a streamdeck or a macro board, heck it can even be used as a gameing only keyboard, i used shrpr3d to make the 3d3 models/ assemble the 3d models as i have built off of existing models as well!
i was un aware about the minimum 3 journals requirement or else i would have well documented this even more
Samir Ghimire
added to the journal ago
completed EVERYTHING !!!
I managed to finish the schematics 3d model of the case, pcb design and everything in this past week, I decided to finish everything in one go then upload it all. I have taken help of one of my brothers to write the firmware as well, which maybe needed to be configured later on. I hope this is enough software so that now I can finally start on the hardware side of things
Samir Ghimire
started Macro Pad ago